1. Misconception one: If the air conditioner is not cool, it must be fluorine-loving This is a common sense error, which is reasonable in special cases, but it is still undesirable in most cases.
2. Many drivers know that too low tire pressure is easy to cause tire wear, but if the tire pressure is too high, the car is prone to flat tires, which is more dangerous! Some drivers like to fill the tire pressure higher, thinking that this can be both overloaded and fuel-saving. However, if the tire pressure is too high, the tire will be less connected to the ground, the wear will be aggravated, and it is also easy to puncture the tire.
3. Misconception: The more oil, the better. If there is too much oil, the crankshaft shank and connecting rod will cause violent stirring when the engine is working, which not only increases the internal power loss of the engine, but also causes oil burnout failure due to the increase of oil splashed on the cylinder wall. Therefore, the amount of oil should be controlled between the upper and lower lines of the oil dicator.
1. It's best to spray with the steam injector mentioned above, but there are also some detergents on the market specially designed for cleaning velvet. It's best to use velvet cleaners with a moderately soft and hard brush, which will have a better effect.
2. Professional car wash should add a pre-washing procedure before washing the car. Even if a special pre-washing solution is sprayed on the car body with professional equipment and waits for a minute or two, after soaking, most of the sand and soil can be separated from the car paint, and then rinsed with a water gun, which can avoid the danger of sand and mud scratching the paint when washing liquid.
3. Wash the leather seats with soap. Leather seats are afraid of scratches by hard objects, and even more afraid of the corrosion of chemical detergents. In the past, I went to the car beauty shop for cleaning, and used more foam decontamination agents. After drying, the skin surface became hard and there were small cracks.
4. If you wash the car by yourself, you can take care of all the small corners, and the washed car is very clean. Isolation cream: wax your car. Operation index: ★★★☆ After the car is washed, a protective film should be applied to the car. Although car paint does not need daily care like human skin, frequent waxing is essential.
5. Use special car cleaning liquid. When some people wash cars at home, they will use some cleaning liquids, such as laundry detergent, detergent, etc. to wash the car. In fact, it is not right to do so.
6. Pay attention to the order of car washing. The correct order should be the roof, front and rear covers, side of the body, lamps, bumpers, skirts and wheels. Because the water flows from top to bottom with dirt, only by washing from top to bottom can it be washed clean, water can be saved and scratches be avoided.
Open the window for ventilation. First of all, it is necessary to open more windows for ventilation, which will be conducive to the smell to spread out. If it is not closed all the time, the smell will not spread out. If the space in the car is small, you need to open more windows for ventilation, which is also conducive to maintaining air convection. Lemon removes odors.
The following is the method of removing the smell in the car: fruit peel deodorization: the car owner is used to using some fruit peels to remove the smell in the car. This method is effective and relatively simple to operate. When operating, try to choose grapefruit peel, orange peel, etc., vegetable deodorization method: smoked onions that make people cry, to remove There are also special effects for the smell in the car.
Use smell to coverIn the way to cover the strange smell, you can also put some fragrant fruits in the car to let the fragrance spread for a long time. Some fruits can not only emit fruity fragrance, but also have strong adsorption ability. For example, grapefruit, pineapple, lemon, orange, etc. Eat the leftover grapefruit peel and pineapple peel can also be used as a tool for deodorizing in the car.
Carton making tutorial is as follows: Prepare the necessary materials: toothpaste box, four small bottle caps, double-sided adhesive, Scissors, clay, straws. Cut the toothpaste box according to the picture below, and pay attention to the same size on the left and right sides.
Prepare all the materials, as shown in the figure below: cut the cardboard into a rectangular shape to make the chassis of the car.Draw the chassis of the car with a pen, and the front end is used to hang a rubber band. After sketching, use scissors to reduce the excess part, and the disc of the car is done in this way.
First of all, prepare the double-sided glue bottle cap corrugated paper waste paper box needed for DIY cars. Take the common toothpaste box as an example. Colored pencil and dirt scissors 2. Then cut the toothpaste box with scissors to a half of the length of the length. As shown in the figure below. 3 After that, cut half of the toothpaste box should be cut along the edge.
How to make a handmade car: use a ruler and a knife to cut the toothpaste box into two pieces, one end into a carriage and the other end into a car head, with a ratio of 3:1. Draw the oblique line on the front of the car with a pen and ruler, and then cut it with a knife.
Binance exchange-APP, download it now, new users will receive a novice gift pack.
1. Misconception one: If the air conditioner is not cool, it must be fluorine-loving This is a common sense error, which is reasonable in special cases, but it is still undesirable in most cases.
2. Many drivers know that too low tire pressure is easy to cause tire wear, but if the tire pressure is too high, the car is prone to flat tires, which is more dangerous! Some drivers like to fill the tire pressure higher, thinking that this can be both overloaded and fuel-saving. However, if the tire pressure is too high, the tire will be less connected to the ground, the wear will be aggravated, and it is also easy to puncture the tire.
3. Misconception: The more oil, the better. If there is too much oil, the crankshaft shank and connecting rod will cause violent stirring when the engine is working, which not only increases the internal power loss of the engine, but also causes oil burnout failure due to the increase of oil splashed on the cylinder wall. Therefore, the amount of oil should be controlled between the upper and lower lines of the oil dicator.
1. It's best to spray with the steam injector mentioned above, but there are also some detergents on the market specially designed for cleaning velvet. It's best to use velvet cleaners with a moderately soft and hard brush, which will have a better effect.
2. Professional car wash should add a pre-washing procedure before washing the car. Even if a special pre-washing solution is sprayed on the car body with professional equipment and waits for a minute or two, after soaking, most of the sand and soil can be separated from the car paint, and then rinsed with a water gun, which can avoid the danger of sand and mud scratching the paint when washing liquid.
3. Wash the leather seats with soap. Leather seats are afraid of scratches by hard objects, and even more afraid of the corrosion of chemical detergents. In the past, I went to the car beauty shop for cleaning, and used more foam decontamination agents. After drying, the skin surface became hard and there were small cracks.
4. If you wash the car by yourself, you can take care of all the small corners, and the washed car is very clean. Isolation cream: wax your car. Operation index: ★★★☆ After the car is washed, a protective film should be applied to the car. Although car paint does not need daily care like human skin, frequent waxing is essential.
5. Use special car cleaning liquid. When some people wash cars at home, they will use some cleaning liquids, such as laundry detergent, detergent, etc. to wash the car. In fact, it is not right to do so.
6. Pay attention to the order of car washing. The correct order should be the roof, front and rear covers, side of the body, lamps, bumpers, skirts and wheels. Because the water flows from top to bottom with dirt, only by washing from top to bottom can it be washed clean, water can be saved and scratches be avoided.
Open the window for ventilation. First of all, it is necessary to open more windows for ventilation, which will be conducive to the smell to spread out. If it is not closed all the time, the smell will not spread out. If the space in the car is small, you need to open more windows for ventilation, which is also conducive to maintaining air convection. Lemon removes odors.
The following is the method of removing the smell in the car: fruit peel deodorization: the car owner is used to using some fruit peels to remove the smell in the car. This method is effective and relatively simple to operate. When operating, try to choose grapefruit peel, orange peel, etc., vegetable deodorization method: smoked onions that make people cry, to remove There are also special effects for the smell in the car.
Use smell to coverIn the way to cover the strange smell, you can also put some fragrant fruits in the car to let the fragrance spread for a long time. Some fruits can not only emit fruity fragrance, but also have strong adsorption ability. For example, grapefruit, pineapple, lemon, orange, etc. Eat the leftover grapefruit peel and pineapple peel can also be used as a tool for deodorizing in the car.
Carton making tutorial is as follows: Prepare the necessary materials: toothpaste box, four small bottle caps, double-sided adhesive, Scissors, clay, straws. Cut the toothpaste box according to the picture below, and pay attention to the same size on the left and right sides.
Prepare all the materials, as shown in the figure below: cut the cardboard into a rectangular shape to make the chassis of the car.Draw the chassis of the car with a pen, and the front end is used to hang a rubber band. After sketching, use scissors to reduce the excess part, and the disc of the car is done in this way.
First of all, prepare the double-sided glue bottle cap corrugated paper waste paper box needed for DIY cars. Take the common toothpaste box as an example. Colored pencil and dirt scissors 2. Then cut the toothpaste box with scissors to a half of the length of the length. As shown in the figure below. 3 After that, cut half of the toothpaste box should be cut along the edge.
How to make a handmade car: use a ruler and a knife to cut the toothpaste box into two pieces, one end into a carriage and the other end into a car head, with a ratio of 3:1. Draw the oblique line on the front of the car with a pen and ruler, and then cut it with a knife.
423.38MB
Check646.83MB
Check319.75MB
Check564.22MB
Check192.14MB
Check558.62MB
Check945.84MB
Check661.95MB
Check232.63MB
Check656.62MB
Check546.21MB
Check186.82MB
Check455.67MB
Check391.91MB
Check589.73MB
Check461.89MB
Check984.79MB
Check881.49MB
Check293.94MB
Check766.62MB
Check114.61MB
Check428.86MB
Check367.45MB
Check239.28MB
Check139.31MB
Check497.56MB
Check729.47MB
Check957.11MB
Check594.71MB
Check773.77MB
Check361.88MB
Check335.96MB
Check765.76MB
Check997.72MB
Check388.32MB
Check147.49MB
CheckScan to install
Binance exchange to discover more
Netizen comments More
1695 芙蓉出水网
2025-01-23 11:28 recommend
2430 烈火真金网
2025-01-23 10:53 recommend
2279 行不由径网
2025-01-23 09:44 recommend
1471 典则俊雅网
2025-01-23 09:43 recommend
1256 摧心剖肝网
2025-01-23 09:39 recommend